Furuno FMD-3200-BB Instruction Manual page 89

[Medium] component (two blocks.)
• Azimuth Propulsion
[Title]: Enter the title of the component.
Azimuth
[Label]: Enter the data name shown at the bottom of the indicator.
[Source]: Select the data source of the azimuth propulsion.
[Unit]: Enter the unit for the azimuth propulsion.
[North Angle]: Enter the north angle relative to the screen. Normally, enter "0".
[Value Mapping]: When the checkbox is checked, if the input azimuth angle is other
than 0° to 359°, this equipment calculates the input value so that the azimuth angle
is within 0° to 359°. For example, the input azimuth angle is "-90°", the displayed
value is "270°". When the checkbox is not checked, this equipment shows the same
value as the input data.
Object
[Label]: Enter the data name of [Object1 (to 4)].
[Source]: Select the data source of the numeric data for [Object1 (to 4)].
[Unit]: Enter the unit for [Object1 (to 4)].
• [Check ETA]
[Title]: Enter the title of the component.
1. INITIAL SETTING AND ADJUSTMENT
1-83