Furuno FMD-3200-BB Instruction Manual page 94

1. INITIAL SETTING AND ADJUSTMENT
• Graph (Wind Speed & Direction)
[Title]: Enter the title of the component.
[Label]: Enter the title of [Wind Speed] and [Wind Direction].
[Source]: Select the source of [Wind Speed] and [Wind Direction].
[Unit]: Enter the unit of [Wind Speed] and [Wind Direction].
[Smoothing]: Select [Apply] to smooth the graph.
[Scale │ Range]: Set the display range of the Y-coordinate. Three display ranges
can be entered.
[Time Span]: Set the display range of the X-coordinate.
[Sample Interval]: Set the interval of [Primary (Y1)] and [Secondary (Y2)] graph plot.
[Scale Resolution]: Select the scale resolution of the graph.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Secondary (Y2) Scale]: Check the check box to show the value input from the data
source of [Secondary (Y2)].
[Mathematical Sign (Scale)]: Check the checkbox to show the minus sign (-) when
the value of the Y-coordinate is minus.
[Mathematical Sign (Value)]: Check the checkbox to hide the minus sign (-) when
the value above graph is minus.
• Heading
[Compass Title]: Enter the title shown at the top of the compass meter.
[Location]: Select the location of the heading sensor from the pull-down list.
[Compass Sensor Name Source]: Enter the name of the heading sensor.
[Compass Primary Source]: Select the data source of the upper pointer.
[Compass Secondary Source]: Select the data source of the lower pointer.
[Primary Label]: Enter the title for the primary source.
[Ruler Title]: Enter the title of the ruler.
[Ruler Primary Source]: Select the data source of the white triangle pointer.
[Ruler Secondary Source]: Select the data source of the gray triangle pointer.
[Start Value]: Set the minimum value of the bar.
[End Value]: Set the maximum value of the bar.
1-88