Furuno FMD-3200-BB Instruction Manual page 90

1. INITIAL SETTING AND ADJUSTMENT
• Command Matrix
[Title]: Enter the title of the component.
[Control Type]: Set the number of columns for the matrix.
[Thruster Num]: Set the number of rows for the matrix.
[Control Type Label]: Enter the text that appears at the top of the matrix.
[Name]: Enter the text that appears at the left side of the matrix.
[Source1] to [Source8]: Set the source for the thruster data for the matrix.
• Dial Meter
[Title]: Enter the title of the component.
[Dial Title]: Enter the text to show above the indicator.
[Primary Source]: Select the data source of the long pointer of the indicator.
[Secondary Source]: Select the data source of the outer pointer of the indicator.
[Peak Source]: Select the data source of the short pointer of the indicator.
[Unit]: Set the unit of the data.
[Start Value]: Set the minimum value of the indicator.
[End Value]: Set the maximum value of the indicator.
[Angle]: Define the extent of the dial.
[Rotation]: It can be rotate the direction of the indicator. Normally, set to "0".
[Scale Resolution]: Select the scale resolution.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
1-84