Furuno FMD-3200-BB Instruction Manual page 120

4. HUB-3000 IGMP QUERIER SETTING
5. Click [OK].
6. Click [Setup], [Serial Port] to show the setting window.
7. Set the options as shown below on the setting window.
• [Baud rate]: 9600
• [Stop]: 1 bit
8. Press the Enter key on "Tera Term".
You are asked to enter the user name and password.
9. Enter the user name and password as shown below.
• [User name]: admin
10. Enter the word "enter" and press the Enter key.
11. Press the Enter key again.
12. Enter "show ip igmp-snooping" in the "Switch#" field and press the Enter key.
Confirm the configuration of HUB-3000. When "Disabled" appears in the "Querier"
field, do the following.
Switch> enter
Switch#Jan 1 20:32:14 User admin enter privilege mode from console 0, level
= 15
Switch# show ip igmp-snooping
Global IGMP snooping configuration:
-----------------------------------
Globally enable
VLAN nodes
Dlf-frames filtering : Enabled
Sensitive
Querier
Querier address
Router age
13. Enter "config" and press the Enter key.
14. Enter "ip igmp-snooping querier" and press the Enter key.
15. Enter "show ip igmp-snooping" and press the Enter key.
16. Confirm that "Enabled" appears in the "Querier" field.
4-2
Username: admin
Password: admin
Welcome to
Switch>
: Enabled
: 1
: Disabled
: Disabled
: 10.0.0.200
: 260 s
• [Data]: 8 bit
• [Flow control]: none
HUB-3000 GigabitHUB
• [Password]: admin
• [Parity]: none