Furuno FMD-3200-BB Instruction Manual page 84

1. INITIAL SETTING AND ADJUSTMENT
[Decimal Place]: Check the checkbox to show the value after decimal point.
Zero Padding: Set the number of decimal points to show "0" in the [Source] for each
object.
[Unit]: Enter the unit.
[5 lines]: Check the checkbox to show 5 lines data on the component.
• Dual Horizontal Bar
[Title]: Enter the title of the component.
[Primary Source]: Select the data source of the bar.
[Secondary Source]: Select the data source of the triangle below the bar.
[Start Value]: Set the minimum value of the bar.
[End Value]: Set the maximum value of the bar.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
[Mirror Vertically]: Check the box to invert the position of the bar and value.
• Empty
[Title]: Enter the title of the component.
• [Final ETA]
[Title]: Enter the title of the component.
• Generator Engine
[Title]: Enter the title of the component.
[Label]: Enter the data name.
[Actual Source]: Select the data source of the actual engine generating power.
[Rated Source]: Select the data source of the rated engine generating power.
1-78