Furuno FMD-3200-BB Instruction Manual page 86

1. INITIAL SETTING AND ADJUSTMENT
[Primary Source]: Select the data source of the green bar.
[Secondary Source]: Select the data source of the triangle below the bar.
[Start Value]: Set the minimum value of the bar.
[End Value]: Set the maximum value of the bar.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
[Mirror Vertically]: Check the checkbox to invert the position of the bar and value.
• Horizontal Ruler
[Title]: Enter the title of the component.
[Top Left]: Select the data source of the value shown at the upper left of the bar.
[Top Center]: Select the data source of the value shown above the bar.
[Top Right]: Select the data source of the value shown at the upper right of the bar.
[Bottom Left]: Enter the text shown at the lower left of the bar.
[Bottom Center]: Enter the text shown below the bar.
[Bottom Right]: Enter the text shown at the lower right of the bar.
[Primary Source]: Select the data source of the indication shown with white triangle.
[Secondary Source]: Select the data source of the indication shown with gray trian-
gle.
[Start Value]: Set the minimum value of the bar.
[End Value]: Set the maximum value of the bar.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
• Numeric Data Display
[Title]: Enter the title of the component.
1-80