Own Ship Setting] Menu - Furuno FMD-3200-BB Instruction Manual

1.3

[Own Ship Setting] Menu

Enter the information for ship parameters/CCRP, antenna unit, GPS sensor, AIS tran-
sponder, echo sounder (E/S), and SDME sensor. As for the symbol for sensors, there
are six colors to show the priority: white (CCRP), cyan (Radar), green (GPS), magenta
(AIS), orange (E/S) and blue (SDME) in that order.
1. Access the [Common Installation Setting] menu and click [Own Ship Setting] on
the tab bar.
2. Activate each field and enter own ship's data, using the table below for reference.
Menu item/interactive field
[Vessel Type]
[Ship Length (LOA, m)]
[Ship Width (m)]
[Summer Load Line (m)]
[MAX ROT (deg/min)]
[Block Coefficient]
[Min Maneuvering Speed (kn)] Minimum maneuvering speed. This value is used as
[Center of Gravity]
[Pivot Point]
[CCRP]
1. INITIAL SETTING AND ADJUSTMENT
Description
Own ship type among [Fast/Super Small], [Fast/
Small], [Slow/Big] and [Super Tanker].
Own ship's length, in meters.
Own ship's width, in meters.
Distance between own ship's hull and the summer
load line, in meters.
Own ship's maximum angular velocity (Rate of turn).
Own ship's block coefficient.
the threshold for the alert 159 "Low Speed Alarm".
The TCS is available when the vessel cruise at the set-
ting speed or more.
Note: Keep in mind the performance of the autopilot to
set the own ship's minimum maneuvering speed.
Own ship's center of gravity, in meters, set by X, Y and
Z axis.
Own ship's pivot point, in meters, set by X, Y and Z
axis. Approximately 80% of the ship's length is recom-
mended for the pivot point. For example, the ship's
length is 350 m, enter "280 m" to [Y (m)]. For TCS, the
XTE is calculated on the value set at here.
Select the [CCRP] you wish to setup by left-clicking the
check box to the left of each CCRP number. You can
set up a maximum of four CCRP positions. Set up of
[CCRP1] is required.
1-13