Furuno FMD-3200-BB Instruction Manual page 97

• Vertical Bar
[Title]: Enter the title of the component.
[Top Source]: Select the data source for the data at the top of the vertical bar.
[Bottom Source]: Select the data source for the data at the bottom of the vertical bar.
[Primary Source]: Select the data source of the bar.
[Secondary Source]: Select the data source of the triangle indicator.
[Start Value]: Set the minimum value of the bar.
[End Value]: Set the maximum value of the bar.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
[Mirror Horizontally]: Check the checkbox to invert the position of the bar and value
horizontally.
[Average Value]: Check the checkbox to show the average value.
• Vertical Graph (Middle)
[Title]: Enter the title of the component.
[Label Source]: Enter the source of text shown on the right of the graph. Manual in-
put is available.
[Mode Source]: Enter the source of text shown on the right of the value indication.
Manual input is available.
[Label]: Enter the title of [Primary] and [Secondary].
[Source]: Select the data source of [Primary] and [Secondary].
[Source (sub)]: Set the other data source in the same range as the data of [Primary].
The [Source (sub)] appears only when the source of [Secondary] is not entered.
[Unit]: Set the unit in the [Primary] and [Secondary].
[Scale │ Range]: Set the display range of the X-coordinate. [Primary] is for the
range of the upper of the graph, [Secondary] is for the range of the lower of the
graph.
[Time Span]: Set the display range of the Y-coordinate.
[Sample Interval]: Set the interval of the graph plot.
[Scale Resolution]: Select the scale resolution of the graph.
1. INITIAL SETTING AND ADJUSTMENT
1-91