Furuno FMD-3200-BB Instruction Manual page 105

For FCR-29 series
1) Press and hold the 1 HL OFF key, then press the MENU key five times.
2) Select [9 RADAR INSTALLATION][4 TT PRESET][1 TTM/TTD PREFER-
ENCE] and then select [TRUE].
4. Access the [Common Installation Setting] menu on the ECDIS.
5. Open the [Own Ship Setting] menu, then select [Radar Antenna] on the menu bar.
6. For one antenna unit, check [RAS001]. For two antenna units, check [RAS001]
and [RAS002].
For FAR-30 series
1. Press and hold the 1 HL OFF key, then press the MENU key five times.
2. Select [9 RADAR INSTALLATION][4 TT PRESET][1 TTM/TTD PREFER-
ENCE] and then select [TRUE].
3. Access the [Common Installation Setting] menu on the ECDIS.
4. Open the [Own Ship Setting] menu, then select [Radar Antenna] on the menu bar.
5. For one antenna unit, check [RAS001]. For two antenna units, check[ RAS001]
and [RAS002].
For FAR-28 series
1. Press and hold the 1 HL OFF key, then press the MENU key five times to open
the [RADAR INSTALLATION] menu.
2. Select [0 NEXT].
3. Select [2 NETWORK SETTINGS], then set [2 LAN1•3 IP ADDRESS] to [CLASS
C].
4. Go back to the first page of the [RADAR INSTALLATION] menu, then select [5 IN-
STALLATION].
5. Set the antenna number ([3 RADAR NO]), taking care not to duplicate the antenna
number of other radars.
6. Go back to the second page of the [RADAR INSTALLATION] menu, then select
[3 OTHER SETTINGS].
7. Set [4 ECDIS] to [LAN].
8. Go back to the first page of the [RADAR INSTALLATION] menu, then select [6 TT
PRESET]  [2 TT DATA OUTPUT].
9. Set [2 SELECT SENTENCE] to [TTM] or [TTD].
10. Set [3 TTM/TTD REFERENCE] to [TRUE].
11. If you want to share the ship's speed and location data with the ECDIS, select
[ECDIS] on the either of the following menu items:
• Main menu  [7 INFORMATION BOX]  [2 OWN SHIP INFO]  [3 SPEED]
 [2 SHIP SPEED]
• Main menu  [7 IINFORMATION BOX]  [2 OWN SHIP INFO]  [4 OWN
SHIP POSN]  [2 POSITION SOURCE]
Note: The settings for the above two menu items are shared. When either one is
changed, the other is also changed.
1. INITIAL SETTING AND ADJUSTMENT
1-99