Furuno FMD-3200-BB Instruction Manual page 25

Item
[VNC Connection No use.
Enable]*
[Sub Display
Mode]*
[Server IP Ad-
dress]*
[Server Port
Number]*
[Server Login
Password]*
[Additional Pa-
rameters]*
[Backup EC- Check the check-box to install the Chart Radar as a Back-up ECDIS.
DIS]**
*: ECDIS only
**: Chart Radar only
4. Click [Serial Input/Output] of [No.1 ECDIS] or [No.1 Chart Radar] on the menu bar.
[Serial 01] to [Serial 04] can input/output at 38,400 bps. For high-speed signal in-
put (such as AIS and Gyro) or TTD sentence output, click [Details] to set the baud
rate as 38,400 bps.
The connector no. on the I/O board of the processor unit EC-3000 and the corre-
sponding serial port no. are shown below.
Connector No.
J3
J4
J5
J6
5. Check the applicable checkboxes of [Serial No.] according to sensor connection.
6. Set the items referring to the table shown below.
Item
[Equipment Select the Equipment ID from the pull-down list.
ID] The pull-down list options depend on the setting at [Sensor Setting].
Serial Port No. Connector No.
Serial 01 J7
Serial 02 J8
Serial 03 J9
Serial 04 J10
1. INITIAL SETTING AND ADJUSTMENT
Remarks
Serial Port No.
Serial 05
Serial 06
Serial 07
Serial 08
Remarks
1-19