Furuno FMD-3200-BB Instruction Manual page 22

1. INITIAL SETTING AND ADJUSTMENT
5. Click the [Details] button to set the following items, referring to the table shown be-
low.
[Sensor Name]
[Manufacture]
[Sensor Type No.]
[System Alert ID]
[X (m)], [Y (m)], [Z (m)]
[Alert Information Source]
[ALF Text Information]
[Sensor Network]
[Gateway Network]
6. Set [Gyro Sensor], [ROT GYRO Sensor], [AIS Transponder], [Echo Sounder],
[SDME Sensor], [NAVTEX Receiver], [Water Temperature], [Wind Sensor], [Mag-
net Compass Sensor], [Current Sensor], [Rudder Sensor], [HCS], [VDR], [BN-
WAS], and [Other Sensor] in a similar manner.
Note 1: Only sensors connected to the processor unit should be set. For the Chart
Radar, the default sensor unit settings are as follows.
1-16
For [VDR]
Item
Enter the appropriate sensor name.
Select the manufacturer of sensor from the pull-down list.
Note: If the required manufacturer does not appear, add it
manually (see section 1.4.9).
Select the type of sensor from the pull-down list.
Note: If the required type does not appear, add it manually
(see section 1.4.9).
The identification number that is assigned in the system is
shown in this field. Do not change the setting.
Set the location of X, Y and Z for [Other Sensor] only.
Set the source of alert definition to show on the display
when the alert message is received in an ALF sentence.
• [Alert Definition]: Show the alert definition registered to
the processor unit.
• [Alert Sentence]: Show the alert definition included in the
ALF sentence.
Select the type of the 2/2 packet text information of ALF
sentence.
• [All Alert Name]: Select this item if all alert text is includ-
ed in the 2/2 packet of the ALF sentence. The text infor-
mation on the 2/2 packet of the ALF sentence is shown
as the alert name in the alert list/log.
• [Remaining Alert Name]: Select this item if the alert text
is divided in 1/2 and 2/2 packets of the ALF sentence.
The text information for both the 1/2 and 2/2 packets of
the ALF sentence is shown as the alert name in the alert
list/log.
• [Decision Support]: Select this item if the alert details in-
formation (Decision Support) is included in the 2/2 pack-
et of the ALF sentence. The text information for the 2/2
packet of the ALF sentence is shown as the alert details
in the alert list/log.
Set the IP address of sensor network for [VDR] only.
Set the IP address of gateway network for [VDR] only.
For [Other Sensor]
Remarks
For other units