Furuno FMD-3200-BB Instruction Manual page 58

1. INITIAL SETTING AND ADJUSTMENT
Parameter
Track Control
XTE Gain - Open Sea*
XTE Gain - All Waters*
Alert Talker ID
Track Pilot Talker ID
No Start Period Before
Turn*
Use Advance Values from
Autopilot
End Tolerance
4
Curved EBL*
Length
Max ROT at Start
4
Program Track*
Warning Escala- Change to Alarm
tion
Interval
Course Change Early Course Change
Alert Timing
Approach Alarm
1
* : Parameters effect correcting the XTE. They are available for GoAW mode of PT-
500A and FAP-2000.
2
* : Parameters are available for PT-500, PR-6000 and PR-9000.
3
* : Parameters are available for PR-6000, PR-9000 and NP-5400.
4
* : Parameters are available for FAP-2000 and FAP-3000.
1-52
2
2
3
Explanation
Adjust the gain for the XTE. To adjust the gain val-
ue manually, activate the checkbox for [Manual]
and enter the setting value.
Keep the default setting.
Select "EI" to use autopilot NP-5400. Select "II" for
all other autopilots.
The TCS is unavailable when the time to the WOP
(Wheel Over Point) is shorter than the setting val-
ue here.
Check the checkbox to use PT-900.
• Checked: Use the forwarding distance set at
autopilot.
• Unchecked: Use the forwarding distance set at
ECDIS.
Keep the default setting.
Adjust the forwarding distance for the curved EBL.
Starting PT is disabled if ROT exceeds this limit.
Check to have the alert priority change from Warn-
ing to Alarm when the alert 150 "Early Course
Change Indication" is not acknowledged while the
TCS is not engaged. If not checked the priority re-
mains at Warning and the alert is re-generated.
Sets both the time to wait until the alert priority is
changed from Warning to Alarm and time wait until
the alert is re-generated.
Threshold value for the alert 150 "Early Course
Change Indication".
Threshold value for the alert 151 "Actual Course
Change Indication".