Furuno FMD-3200-BB Instruction Manual page 106

1. INITIAL SETTING AND ADJUSTMENT
12. If you want to show the marks received from the ECDIS on the FAR-28 screen,
open the main menu  [2 MARKS]  [6 ECDIS MARKS DISPLAY], then select
[ON] or [OFF] as appropriate.
13. Access the [Common Installation Setting] menu on the ECDIS.
14. Open the [Own Ship Setting] menu, then select [Radar Antenna] on the menu bar.
15. For one antenna unit, check [RAS001]. For two antenna units, check [RAS001]
and [RAS002].
For non-Furuno radar
1. Open [Installation Parameters][Sensor Setting][Other Sensor] menu.
2. Check [OTR001] and enter [RA0201] to [SFID]. Do not use other than [RA0201]
to [RA0204].
Note 1: When entering the SFID, do not use the prefix "AI" (AIS excluded) or "II".
Note 2: Do not enter the same SFID as any other equipment in the network.
3. Select [Serial Input/Output] of the processor unit you want to set on the menu bar.
4. Check the serial port to receive the TT symbol data and select [OTR001] from the
[Equipment ID] pull-down list.
The example shown below indicates that the [Serial 08] port of [ECD001] receives
the TT symbol data.
1-100