Furuno FMD-3200-BB Instruction Manual page 11

For the Chart Radar: Setting range: [CRA001] to [CRA004]. Do not select
[CRA005] to [CRA010].
The [Equipment Name], [Equipment Type No.], and [IP Address] are automatically
entered according to the Equipment ID. For details, see the Equipment ID list is at
the back of this manual.
Note 1: For the first ECDIS, set [Equipment ID] to [ECD001]. For the first Chart
Radar, set [Equipment ID] to [CRA001].
Note 2: Assign a different Equipment ID to each processor unit.
Note 3: [Serial No.] is entered before shipment. If you change the SSD or delete
[Serial No.] by mistake, click the box of [Serial No.] to enter the serial number of
the processor unit (example: xxxx-xxxx).
Note 4: The properties of data transmitted under IEC61162-450 protocol are
changed according to the Equipment ID settings.
• The Processor Unit's SFID, Device No. and Channel change as shown in the
following table.
Equipment ID
CRA001
CRA002
CRA003
CRA004
ECD001
ECD002
ECD003
ECD004
ECD005
ECD006
ECD007
ECD008
ECD009
ECD010
ECD011
ECD012
ECD013
ECD014
ECD015
ECD016
• When this unit has Back-up ECDIS enabled (see subsection 1.4.2) and Back-
up ECDIS mode is active, the SFID changes as shown below.
*: This SFID is applied to all ECDIS-related functions.
3. Select [FMD-3200|3300] or [FCR-29] from the [Equipment Type No.] pull-down
list.
Note: Do not use [FCR-29 ED.1] and [FCR-29 ED.2].
1. INITIAL SETTING AND ADJUSTMENT
SFID
RA0001
RA0002
RA0003
RA0004
EI0001
EI0002
EI0003
EI0004
EI0005
EI0006
EI0007
EI0008
EI0009
EI0010
EI0011
EI0012
EI0013
EI0014
EI0015
EI0016
Back-up ECDIS Back-up ECDIS
is not active is active*
RA0001
RA0002
RA0003
RA0004
Device No. Channel
61 1, 2, 3
62 1, 2, 3
63 1, 2, 3
64 1, 2, 3
21 1, 2, 3
22 1, 2, 3
23 1, 2, 3
24 1, 2, 3
25 1, 2, 3
26 1, 2, 3
27 1, 2, 3
28 1, 2, 3
29 1, 2, 3
30 1, 2, 3
31 1, 2, 3
32 1, 2, 3
33 1, 2, 3
34 1, 2, 3
35 1, 2, 3
36 1, 2, 3
EI0021
EI0022
EI0023
EI0024
1-5