Vdr] Window - Furuno FMD-3200-BB Instruction Manual

12. To connect a service gateway, select [Connected] at [Service Gateway] then the
IP address and the port number appear below the [Connected] item. Do not
change these settings.
13. Click [Save] on the info bar. Several confirmation messages appear. Click [OK] to
reboot the system. To discard all changes, click [Discard Changes].
Note 1: If the monitor does not display images correctly after system reboot, re-
boot the monitor.
Note 2: When the message shown below appears after system reboot, confirm
the connection and settings of the system.
1.2.3

[VDR] window

1. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
2. Click [VDR] on the menu bar.
3. If a VDR is connected, select [Connected] from the [Connection] pull-down list.
Refer to the table below to set the items in the menu.
Menu item/
interactive field
[Monitor]
[Transmit per 15 sec.]
[Transmission Rate]
[Image Format]
[JPEG Quality]
[Network]
[Transmission Timing]
[Destination]
1. INITIAL SETTING AND ADJUSTMENT
Select the DVI port connected with the VDR.
Set the number of transmissions in 15 seconds.
Set the transmitting rate.
Set the image format.
Set the quality of JPEG data. Available when [JPEG] is se-
lected for [Image Format].
Select the network connected with the VDR.
Set the delay timing. The delay is applied regardless of the
Display Mode selected (RADAR or Back-up ECDIS).
Set the IP address and port of the destination.
Description
1-9