GE Dash 3000 Service Manual page 48

Remote Control
3-4
Installation: Connections
The RAC 2A module housing does not have an Analog Output connector.
power switch
The remote control connects to the monitor via a communications cable
which plugs into an Autoport to Mport adapter before it is inserted into
the Aux port on the Dash monitor or the Dash Port docking station.
Aux port
The remote control is programmed for specific care areas (adult,
neonatal, or operating room).
NOTE
The error message WARNING: REMOTE MISMATCHED WITH
MONITORING MODE displays if a mismatched remote control is
connected to the monitor.
Dash 3000/4000 Patient Monitor
2000966-339
AC power
Async Comm
006A
remote control
822A
adapter
Auto Port to the
monitor's Aux Port
Revision A