GE Dash 3000 Service Manual page 222
Patient monitor
Hide thumbs
Also See for Dash 3000:
- Specifications (8 pages) ,
- Service manual (282 pages) ,
- Operator's manual (270 pages)
Table of Contents
Advertisement
Verify Wireless LAN is Enabled
Verify the Wireless LAN ID Number
8-42
Field Replaceable Units and Upgrades: Main Unit Components
Confirm the configuration of the optional Wireless LAN.
1. Activate the Boot Code:
a. Hold down NBP GO/STOP and ZERO ALL.
b. Press and release the Trim Knob control.
c.
Keep holding NBP GO/STOPNBP GO/STOP and ZERO ALL
until the Boot Code information appears on the display.
2. Select SERVICE MENU > SET CONFIGURATION.
3. In the Configuration Menu, select Configure Wireless LAN.
4.
Select Set SSID to factory default.
5. Verify Wireless LAN is set to Enable.
6. Select Exit > Exit. Reboot the monitor (press and release NBP GO/
STOP, ZERO ALL and the Trim Knob control.
1. Select MORE MENU > MONITOR SETUP > REVISION AND ID.
2. Select Next > Next.
3. Verify that WIRELESS LAN ID is showing US 01 V4.65 xxxxxx. If no
ID is displayed, complete the following tasks.
a. Recheck the setup in the Boat Loader menu.
b. Check if the Symbol PC card is installed correctly
Dash 3000/4000 Patient Monitor
2000966-339
Revision A
Advertisement
Table of Contents
Troubleshooting
