Mitsubishi Electric MELDAS C6 Interface Manual page 313

B con-
Signal name
tact
SEARCH & START
—
PROGRAM NO.
[Function]
The No. of the program to be searched with search & start is designated.
[Operation]
Set the No. of the program to be searched with search & start with a binary value.
(Note 1) The program No. must be set before the search & start signal is input.
(Note 2) If a machining program No. is not designated or if an illegal No. is designated, and error
signal will be output when the search operation is executed.
[Related signals]
(1) Search & start (SS: Y7B2)
(2) Search & start error (SSE: X635)
B con-
Signal name
tact
NO. OF WORK MACHINING
—
(MAXIMUM VALUE)
[Function]
The No. of work machining maximum value are notified by the controller to the PLC.
[Operation]
Refer to the No. of work machining current value (R240, 241).
B con-
Signal name
tact
—
LOAD METER 1, 2
[Function] [Operation]
The load meter can be displayed on the coordinate value screen just be setting a value in the
corresponding file register.
Refer to the section on "load meter display" in the "PLC Programming Manual" for details.
6. EXPLANATION OF INTERFACE SIGNALS
6.4 PLC Output Signals (Data Type: R***)
Signal
abbreviation
Signal
abbreviation
Signal
abbreviation
6-4-23
1st system 2nd system
R938, R939 R1038, 1039
1st system 2nd system
R940, R941 R1040, 1041
1st system 2nd system
R942~945 R1042~1045 R1142~1145
3rd system
R1138, 1139
3rd system
R1140, 1141
3rd system