Mitsubishi Electric MELDAS C6 Interface Manual page 253

The relationship between "handle axis No." and "motion axis" is as follows:
Handle axis No.
Motion axis
X axis (1st axis) selected
Y axis (2nd axis) selected
Z axis (3rd axis) selected
#4 axis (4th axis) selected
"2nd handle valid" signal
Set the No. of the axis to be
moved with the nth handle.
[Related signals]
(1) 1st handle axis No. (HS11~HS116: Y740~744)
(2) 3rd handle axis No. (HS31~HS316: Y750~754)
B con-
Signal name
tact
—
2ND HANDLE VALID
[Function] [Operation]
This signal is the same as "1st handle valid" signal in function and operation, except that it is
applicable only to 2-axis or 3-axis handle specification (two or three handles are required).
Refer to the above table for the relation with the "2nd handle axis No." (HS21~HS216).
[Related signal]
(1) 2nd handle axis No. (HS21~HS216: Y748~74C)
6. EXPLANATION OF INTERFACE SIGNALS
6.3 PLC Output Signals (Bit Type: Y***)
HS
— —
2S
1 — —
1 — —
1 — —
1 — —
1st handle
1st handle axis No.
Signal
abbreviation
HS2S
6-3-56
HS HS HS HS HS
216 28 24 22 21
0 0 0 0 1
0 0 0 1 0
0 0 0 1 1
0 0 1 0 0
2nd handle
2nd handle axis No.
1st handle valid (HS1S: Y747)
3rd handle valid (HS3S: Y757)
1st system 2nd system
Y74F Y82F
3rd handle
3rd handle axis No.
3rd system
Y90F