Mitsubishi Electric MELDAS C6 Interface Manual page 267

B con-
Signal name
tact
HANDLE/INCREMENTAL
— FEED MULTIPLICATION
(Code method)
[Function]
Amount of feed motion per pulse from the manual pulse generator in HANDLE feed mode, or
amount of feed motion per shot in incremental feed mode (±J1~±J14: "ON") is multiplied by this
signal.
[Operation]
This signal (MP1~4) is set with the code method.
When this code mode is selected, the true amount of feed motion (per pulse feed in handle feed
mode, and per ON/OFF of ±Jn value in incremental feed mode) is the product obtained by
multiplying originally set amount of feed by multiplier MP1, MP2, MP4.
The relationship between multiplier code (MP1~4) and multiplication in each feed mode is as
follows.
MP4 MP2 MP1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
[Related signal]
Handle mode (H: Y701)
Incremental mode (S: Y702)
6. EXPLANATION OF INTERFACE SIGNALS
6.3 PLC Output Signals (Bit Type: Y***)
Signal
abbreviation
MP1~MP4
Multiplication in
HANDLE feed
0 1
1 10
0 100
1 1000
0 1
1 10
0 100
1 1000
1st system
Y780~782
Multiplication in
INCREMENTAL feed
1
10
100
1000
5000
10000
50000
100000
6-3-70
2nd system 3rd system
Y860~862 Y940~942