Mitsubishi Electric MELDAS C6 Interface Manual page 222

B con-
Signal name
tact
ZERO POINT INITIALIZATION
—
SET MODE nTH AXIS
[Function]
This selects the zero point initialization mode with the marked point alignment method in the
absolute position detection system.
[Operation]
The zero point initialization mode is selected with this signal.
Refer to the section on "Zero point initialization set complete (ZSFn)" signal for details on the
operations.
(Note 1) This signal is a function signal for zero point initialization, and is not a signal that selects
the operation mode. Select the jog mode or handle mode to move the axis to a required
position.
(Note 2) This signal is valid for the following specifications.
When servo detection specification (motor detector, servo system) is the absolute
position detection system.
When "TYPE" on the [ABS. POSI PARAM] screen is set to "2".
[Related signals]
(1) Zero point initialization set complete (ZSFn: X44A)
(2) Zero point initialization set error complete (ZSEn: X44B)
(3) In zero point initialization set (X44C)
(4) Zero point initialization set incomplete (X44D)
(5) Zero point initialization set start (ZSTn: Y453)
6. EXPLANATION OF INTERFACE SIGNALS
6.3 PLC Output Signals (Bit Type: Y***)
Signal
abbreviation
AZSn
6-3-25
1st axis 2nd axis
Y452 Y482
3rd axis
Y4B2