Mitsubishi Electric MELDAS C6 Interface Manual page 132

B con-
Signal name
tact
—
F1-DIGIT NO. (1, 2, 4)
[Function]
F1-digit feed function No. is output.
[Operation]
When F1-digit feed command specified in memory or MDI operation is executed, No. of that F1-digit
feed function is set with a code.
B con-
Signal name
tact
— IN SYNCHRONIZATION
[Function]
This signal indicates the in synchronization state.
[Operation]
This signal turns ON when the synchronization command is issued from one part system, and
retains ON until the corresponding synchronization command is issued from the other part system.
This signal turns OFF when synchronization is completed.
This signal remains OFF when synchronization is not used.
6. EXPLANATION OF INTERFACE SIGNALS
6.1 PLC Input Signals (Bit Type: X***)
Signal
abbreviation
F11~F14
Signal
abbreviation
6-1-43
1st system 2nd system
X638~63A X6B8~6BA
1st system 2nd system
X63C X6BC
3rd system
X738~73A
3rd system
X73C