Mitsubishi Electric MELDAS C6 Interface Manual page 254

B con-
Signal name
tact
—
3RD HANDLE AXIS NO.
[Function]
This signal selects which handle to move with the 3rd handle when using the 3-axis handle
specifications (when three handles are required).
[Operation]
For axis motion controlled by the 3rd handle:
(1) Select HANDLE mode.
(2) Specify axis No. for 2nd handle axis No.
(3) Turn ON "1st handle valid" signal (HS2S).
(4) Turn the handle (handwheel) ... motion will start.
The relationship between "handle axis No." and "motion axis" is as follows:
Handle axis No.
Motion axis
X axis (1st axis) selected
Y axis (2nd axis) selected
Z axis (3rd axis) selected
#4 axis (4th axis) selected
"3rd handle valid" signal
Set the No. of the axis to be
moved with the nth handle.
[Related signals]
(1) 1st handle axis No. (HS11~HS116: Y740~744)
(2) 2nd handle axis No. (HS21~HS216: Y748~74C)
6. EXPLANATION OF INTERFACE SIGNALS
6.3 PLC Output Signals (Bit Type: Y***)
Signal
abbreviation
HS31~HS316
HS
— —
3S
1 — —
1 — —
1 — —
1 — —
1st handle
1st handle axis No.
6-3-57
1st system 2nd system
Y750~754 Y830~834
HS HS HS HS HS
316 38 34 32 31
0 0 0 0 1
0 0 0 1 0
0 0 0 1 1
0 0 1 0 0
2nd handle
2nd handle axis No.
1st handle valid (HS1S: Y747)
2nd handle valid (HS2S: Y74F)
3rd system
Y910~914
3rd handle
3rd handle axis No.