Mitsubishi Electric MELDAS C6 Interface Manual page 308

B con-
Signal name
tact
MANUAL RANDOM FEED
—
3RD AXIS MOVEMENT DATA
[Function] [Operation]
"Manual random feed 3rd axis movement data" is for the axis whose number is specified by
"Manual random feed 3rd axis axis number (CX31~CX316)."
The other conditions are the same as for "Manual random feed 1st axis movement data" explained
in the previous section.
B con-
Signal name
tact
—
OT IGNORED
[Function]
When this signal is used, stroke end error can be avoided without eternal wiring for stroke end
signal (remote I/O connector pin No. fixed singal) provided for each axis. "Stroke end" signal ON
axis for which the "OT ignored" signal is set can be used for other purpose.
[Operation]
"Stroke end" signal associated with a specific axis motion can be ignored.
The interface for this signal is as follows:
File register (R) F E D C B A 9
(Note 1) The signal is applicable to (+) and (-) motion at the same time (ignored when "ON").
(Note 2) "OT" is abbreviation of "Over Travel".
6. EXPLANATION OF INTERFACE SIGNALS
6.4 PLC Output Signals (Data Type: R***)
Signal
abbreviation
Signal
abbreviation
8 7
6-4-18
1st system 2nd system
R918, 919 R1018, 1019
1st system 2nd system
R920 R1020
6 5 4 3 2 1 0
3rd system
R1118, 1119
3rd system
R1120
Bit
1st axis OT ignored
2nd axis OT ignored
:
14th axis OT ignored