Ricoh Type M12 Field Service Manual page 71

Code Meaning
Original length exceeded the
22-00
maximum scan length
22-01 Memory overflow while receiving
Tx or rx job stalled due to line
22-02
disconnection at the other end
The machine cannot store
22-04
received data in the SAF
No G3 parameter confirmation
22-05
answer
Data read timeout during
23-00
construction
The machine software resets itself
25-00 after a fatal transmission error
occurred
F0-xx V.34 modem error
F6-xx SG3 modem error
Suggested Cause/Action
• Divide the original into more than one page.
• Check the resolution used for scanning. Lower
the scan resolution if possible.
• Add optional page memory.
• Wait for the files in the queue to be sent.
• Delete unnecessary files from memory.
• Transfer the substitute reception files to an
another fax machine, if the machine's printer is
busy or out of order.
• Add an optional SAF memory card or hard disk.
• The job started normally but did not finish
normally; data may or may not have been
received fully.
• Restart the machine.
• Update the ROM
• Replace the FCU.
• Defective FCU board or firmware.
• Restart the machine.
• Replace the FCU.
• Update the ROM
• Replace the FCU.
• Replace the FCU.
• Update the SG3 modem ROM.
• Replace the SG3 board.
• Check for line noise or other line problems.
• Try communicating another V.8/V.34 fax.
Error Codes
69