Ricoh Type M12 Field Service Manual page 128

4. Service Tables
Hang-up decision when a negative code
(RTN or PIN) is received during G3
3
immediate transmission
0: No hang-up, 1: Hang-up
4-7 Not used
No
Maximum number of page
0-7 retransmissions in a G3 memory
transmission
No
Remote mode switch (TEL mode)
0 0: Disable
1: Enable (Active)
Remote mode switch (FAX mode)
1 0: Disable
1: Enable (Active)
Remote mode switch (AUTO mode)
2 0: Disable
1: Enable (Active)
3-7 Not used
No
Remote mode switch number
0-3
00-09 (0-9:HEX)
126
Communication Switch 03 (SP No. 1-104-004)
Function
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
Communication Switch 04 (SP No. 1-104-005)
Function
Communication Switch 05 (SP No. 1-104-006)
Function
0: The next page will be sent even if RTN or PIN
is received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or if
ECM is being used.
Do not change these settings.
Comments
Comments
Set this bit to ON when you wish to switch TEL
mode to FAX mode remotely.
Set this bit to ON when you wish to turn on the
remote mode switch after automatic reception
with FAX mode.
Set this bit to ON when you wish to turn on the
remote mode switch after automatic reception
with AUTO mode.
Do not change the settings.
Comments
Enter the number to switch between TEL/FAX
modes using the external phone.