Ricoh Type M12 Field Service Manual page 105

Going into the Energy Saver mode
automatically
1
0: Enabled
1: Disabled
2-3 Not used
Interval for preventing the machine
from entering Energy Saver mode if
there is a pending transmission file.
Bit 5 Bit 4
4-5
0 0
0 1
1 0
1 1
6-7 Not used
No Function
Parallel Broadcasting
0 0: Disabled
1: Enabled
Priority setting for the G3 line.
1 0: PSTN-1 > PSTN-2 or 3
1: PSTN-2 or 3 > PSTN-1
2-7 Not used
System Switch 17 - Not used (do not change these settings)
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode. The LED of the
operation switch is flashing instead of entering
Energy Saver mode.
Use this setting if an external telephone has to be
used when the machine is in the Energy Saver mode.
Do not change these settings.
If there is a file waiting for transmission, the machine
does not go to Energy Saver mode during the
Setting
selected period.
1 min
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver
30 min
mode.
1 hour
24 hours
Do not change
System Switch 16 (SP No. 1-101-023)
1: The machine sends messages simultaneously using
all available ports during broadcasting.
NOTE: If a customer wants to keep a line available
for fax reception or other reasons, select "0"
(Disable).
This function allows the user to select the default G3
line type. The optional SG3 units are required to use
the PSTN-2 or 3 setting.
Do not change these settings.
Bit Switches - 1
Comments
103