Ricoh Type M12 Field Service Manual page 102

4. Service Tables
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
No
0-1 Not used
Enable/disable for direct sending
selection
2
0: Direct sending off
1: Direct sending on
Action when the external handset
goes off-hook
3 0: Manual tx and rx operation
1: Memory tx and rx operation (the
display remains the same)
4-7 Not used
No
100
System Switch 0E (SP No. 1-101-015)
Function
Do not change the settings.
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to "1"
enables direct sending without capture.
Setting this switch to "0" masks the direct sending
function on the operation panel so direct sending with
ScanRouter cannot be selected.
0: Manual tx is possible while the external handset is
off-hook. However, manual tx during handset off-
hook may not be sent to a correct direction. Manual
tx is not possible.
1: The display stays in standby mode even when the
external handset is used, so that other people can use
the machine for memory tx operation. Note that
manual tx and rx are not possible with this setting.
Do not change these settings.
System Switch 0F (SP No. 1-101-016)
Function
Comments
Comments