Ricoh Type M12 Field Service Manual page 107

RTI/CSI/CPS code display
0 0: Enable
1: Disable
1-7 Not used
No Function
Communication after the Journal
data storage area has become full
0
0: Impossible
1: Possible
Action when the SAF memory has
become full during scanning
1*
0: The current page is erased.
1: The entire file is erased.
RTI/CSI display priority
2
0: RTI 1: CSI
0: RTI, CSI, CPS codes are displayed on the top
line of the LCD panel during communication.
1: Codes are switched off (no display)
Do not change these settings.
System Switch 1E (SP No. 1-101-031)
0: When this switch is on and the journal history
becomes full, the next report prints. If the journal
history is not deleted, the next transmission cannot be
received. This prevents overwriting communication
records before the machine can print them.
1: If the buffer memory of the communication records
for the Journal is full, fax communications are still
possible. But the machine will overwrite the oldest
communication records.
• This setting is effective only when Automatic
Journal printout is enabled but the machine
cannot print the report (e.g., no paper).
0: If the SAF memory becomes full during scanning for
a memory transmission, the successfully scanned
pages are transmitted.
1: If the SAF memory becomes full during scanning for
a memory transmission, the file is erased and no
pages are transmitted.
• This setting is effective only when Automatic
Journal printout is enabled but the machine
cannot print the report (e.g., no paper).
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
Bit Switches - 1
Comments
105