Ricoh Type M12 Field Service Manual page 136

4. Service Tables
0-3 Not used
DIS frame length
4
0: 10 bytes 1: 4 bytes
5 Not used
Forbid CED/ANsam output
6 0: Off
1: On (Forbid output)
7 Not used
No
G3 protocol mode used
0 0: Standard and non-standard
1: Standard only
1-6 Not used
Short preamble
7
0: Disabled 1: Enabled
No
DIS detection number
(Echo countermeasure)
0
0: 1
1: 2
1 Not Used
2 Not Used
134
Do not change the settings.
1: The bytes in the DIS frame after the 4th byte will not
be transmitted (set to 1 if there are communication
problems with PC-based faxes which cannot receive the
extended DIS frames).
Do not change the setting.
Do not change this setting (Default: 0: Off), unless
communication problem is caused by a CED or ANSam
transmission.
Do not change this setting.
G3 Switch 02 (SP No. 1-105-003)
Function
Change this bit to 1 only when the other end can only
communicate with machines that send T.30-standard
frames only.
1: Disables NSF/NSS signals (these are used in non-
standard mode communication)
Do not change the settings.
Refer to Appendix B in the Group 3 Facsimile Manual
for details about Short Preamble.
G3 Switch 03 (SP No. 1-105-004)
Function
0: The machine will hang up if it receives the same DIS
frame twice.
1: Before sending DCS, the machine will wait for the
second DIS which is caused by echo on the line.
Do not change the settings.
Do not change the settings.
Comments
Comments