Ricoh Type M12 Field Service Manual page 118

4. Service Tables
Repetition of data when the
received page is longer than the
printer paper
1
0: Off
1: On
Prints the date and time on
received fax messages
2
0: Disabled
1: Enabled
3-7 Not used
No
0-2 Not used
Maximum print width used in the
setup protocol
Bit 4
0
3-4
0
1
1
5-6 Not used
Received message width restriction
in the protocol signal to the sender
7
0: Disabled
1: Enabled
116
1: Default. 10 mm of the trailing edge of the previous
page are repeated at the top of the next page.
0: The next page continues from where the previous
page stopped without any repeated text.
This switch is only effective when user parameter 02 - bit
2 (printing the received date and time on received fax
messages) is enabled.
1: The machine prints the received and printed date and
time at the bottom of each received page.
Do not change the settings.
Printer Switch 01 (SP No. 1-103-002)
Function
Bit 3 Setting
0 Not used
1 A3
0 B4
1 A4
Comments
Do not change the settings.
These bits are only effective when bit 7 of printer
switch 01 is "1".
Do not change the settings.
0: The machine informs the transmitting machine of the
print width depending on the paper size available
from the paper feed stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the setup
protocol (NSF/DIS).
1: The machine informs the transmitting machine of the
fixed paper width which is specified by bits 3 and 4
above.