Ricoh Type M12 Field Service Manual page 130

4. Service Tables
No
The available memory threshold,
below which ringing detection (and
0-7
therefore reception into memory) is
disabled
No
Minimum interval between
0-7
automatic dialing attempts
Communication Switch 0F – Not used (do not change the settings.)
No
Memory transmission: Maximum
0-7 number of dialing attempts to the
same destination
Communication Switch 11 – Not used (do not change the settings.)
No
128
Function
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is below
this threshold, the machine cannot receive any fax
messages.
If this setting is kept at 0, the machine will detect ringing
signals and go into receive mode even if there is no
memory available. This will result in communication
failure.
Communication Switch 0E (SP No. 1-104-015)
Function
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine waits
before it dials the next destination.
Communication Switch 10 (SP No. 1-104-017)
Function
01 – FE (Hex) times
Communication Switch 12 (SP No. 1-104-019)
Function
Comments
Comments
Comments
Comments