Ricoh Type M12 Field Service Manual page 52

3. Troubleshooting
Code
Modem training fails even G3
0-05
shifts down to 2400 bps.
The other terminal did not reply to
0-06
DCS
No post-message response from
0-07 the other end after a page was
sent
50
Meaning
Cross reference
See error code 0-04.
Cross reference
See error code 0-04.
Suggested Cause/Action
• Check the line connection.
• Try adjusting the tx level and/or cable
equalizer.
• Replace the FCU.
• Check for line problems.
• Check the line connection.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the FCU.
• The other end may be defective or incompatible;
try sending to another machine.
• Check for line problems.
• Check the line connection.
• Replace the FCU.
• The other end may have jammed or run out of
paper.
• The other end user may have disconnected the
call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.