Ricoh Type M12 Field Service Manual page 108

4. Service Tables
File No. printing
3 0: Enabled
1: Disabled
Action when authorized reception is
enabled but authorized RTIs/CSIs
are not yet programmed
4
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
5-7 Not used
* This setting can be used for the client machine which has no FCU.
No
0 Not used
Report printout after an original jam
during SAF storage or if the SAF
memory fills up
1
0: Enabled
1: Disabled
2 Not used
Received fax print start timing
(G3 reception)
3
0: After receiving each page
1: After receiving all pages
4-6 Not used
106
1: File numbers are not printed on any reports.
NOTE: The file numbers may not be printed in the
sequential order. If a customer does not like this
numbering, select "0".
0: If the user has stored no acceptable sender RTIs or
CSIs, the user can select "ON" in the authorized
reception setting but the setting becomes invalid
("OFF"). The machine will not be able to receive any
fax messages.
If the customer wishes to receive messages from any
sender that includes an RTI or CSI, and to block
messages from senders that do not include an RTI or
CSI, change this bit to "0", then enable Authorized
Reception.
Otherwise, keep this bit at "1 (default setting)".
Do not change the settings
System Switch 1F (SP No. 1-101-032)
Function
Do not change the settings.
0: When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to "1" if the customer does not want to
have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately after
the machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
Do not change the factory settings.
Comments