Ricoh Type M12 Field Service Manual page 101

4 Not used
Power failure report
5 0: Disabled
1: Enabled (default)
Conditions for printing the protocol
dump list
6 0: Print for all communications
1: Print only when there is a
communication error
7 Not used
No Function
Automatic port selection
0
0: Disabled, 1: Enabled
1-3 Not used
Dialing on the ten-key pad when the
external telephone is off-hook
4
0: Disabled 1: Enabled
On hook dial
5
0: Disabled 1: Enabled
6-7 Not used
Do not change this setting.
1: A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power was
turned off last.
NOTE: If "0" is selected, no reports are printed and
no one may recognize that fax data is gone due to a
power failure.
This switch becomes effective only when system switch
00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
NOTE: The memory size is limited. Use this bit switch
only when some log reports are necessary.
Do not change this setting.
System Switch 0A (SP No. 1-101-011)
When "1" is selected, a suitable port is automatically
selected if the selected port is not used.
NOTE: This bit is useful if all communication lines at a
customer site are not the same quality
Do not change these settings.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine, or if a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change these settings
Bit Switches - 1
Comments
99