Ricoh Type M12 Field Service Manual page 104

4. Service Tables
No
TTI printing position
0: Superimposed on the page data
0
1: Printed before the data leading
edge
1-2 Not used
TTI used for broadcasting
0: The TTIs selected for each Quick/
3 Speed dial are used
1: The same TTI is used for all
destinations
4-7 Not used
No
TTI printing position in the main scan
0-7
direction
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
No
0 Not used
102
System Switch 11 (SP No. 1-101-018)
Function
Change this bit to 1 if the TTI overprints information
that the customer considers to be important (G3
transmissions).
NOTE: If "1" is selected, it is possible that sent data is
printed on two sheets of paper.
Do not change these settings.
1: The TTI (TTI_1 or TTI_2) which is selected for all
destinations during broadcasting.
Do not change these settings.
System Switch 12 (SP No. 1-101-019)
Function
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the
TTI from the left edge of the paper. If the TTI is moved
too far to the right, it may overwrite the file number
which is on the top right of the page. On an A4 page,
if the TTI is moved over by more than 50 mm, it may
overwrite the page number.
System Switch 15 (SP No. 1-101-022)
Function
Comments
Comments
Comments
Do not change the settings.