Ricoh Type M12 Field Service Manual page 100

4. Service Tables
0-2 Not used
Printing dedicated tx parameters on
Quick/Speed Dial Lists
3
0: Disabled
1: Enabled
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
No
Addition of image data from
confidential transmissions on the
0
transmission result report
0: Disabled 1: Enabled
Print timing of communication
reports on the Journal when no
image data was exchanged.
1
0: After DCS/NSS communication
(default),
1: After polling
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on the
error report
3
0: No 1: Yes
98
Do not change these settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (10 bytes
each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are printed
(the other 24 bytes have no use for service
technicians).
Do not change these settings.
System Switch 09 (SP No. 1-101-010)
Function
If this feature is enabled, the top half of the first page
of confidential messages will be printed on
transmission result reports.
0: The Journal is printed only when image data is sent.
1: The Journal is printed when any data is sent.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
This can be used for detecting an error which occurs
rarely.
Comments