Chrysler Sebring 2004 Service Manual page 2282

P0344-CAMSHAFT POSITION SENSOR INTERMITTENT —
TEST
3 Visually inspect the related wire harness including the ground circuit. Look for any
chafed, pierced, pinched, or partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Ensure the Crankshaft Position Sensor and the Camshaft Position Sensor are
properly installed and the mounting bolt(s) are tight.
Refer to any TSBs that may apply.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Go To 4
No
4 Turn the ignition off.
Disconnect the CMP Sensor connector.
Ignition on, engine not running.
Measure the voltage on the (K6) 5 Volt Supply circuit.
Is the voltage between 4.5 and 5.5 volts?
Yes → Go To 5
→ Repair the open or short to ground in the (K6) 5 Volt Supply
No
5 Turn the ignition off.
Carefully disconnect the Battery (-) Ground cable.
Remove the Camshaft Position Sensor.
Inspect the Tone Wheel/Pulse Ring for damage, foreign material, or excessive
movement.
Were any problems found?
Yes → Repair or replace the Tone Wheel/Pulse Ring as necessary.
→ Go To 6
No
6 NOTE: An intermittent glitch in the Crankshaft Position Sensor can cause
the P0344 to set.
Turn the ignition off.
With the DRBIII lab scope probe and the Miller special tool #6801, backprobe the
(K24) CKP Signal circuit in the CKP Sensor harness connector.
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
Ignition on, engine not running.
Wiggle the related wire harness and lightly tap on the Crank Position Sensor.
Observe the lab scope screen.
Start the engine.
Observe the lab scope screen.
Are there any irregular or missing signals?
Yes → Repair as necessary.
→ Go To 7
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
circuit. Use Miller special tool #8815 when checking for an open
circuit to prevent PCM harness connector terminal damage.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
DRIVEABILITY - NGC
353
Continued
APPLICABILITY
All
All
All
All