Grandstream Networks UCM6100 Series User Manual page 59

•
MTU Specifies the Maximum Transmission Unit. (By default, it is 1500)
IPv4 Address
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to
Preferred DNS Server
use it as Primary DNS server.
WAN (when "Method" is set to "Route")
IP Method Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
Subnet Mask
255.255.0.0.
Gateway IP Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
DNS Server 1 Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 2 Enter the DNS server 2 address for static IP settings.
User Name Enter the user name to connect via PPPoE.
Password Enter the password to connect via PPPoE.
Layer 2 QoS Assign the VLAN tag of the layer 2 QoS packets for WAN port.
802.1Q/VLAN Tag The default value is 0.
Layer 2 QoS 802.1p Assign the priority value of the layer 2 QoS packets for WAN port.
Priority Value The default value is 0.
LAN (when Method is set to "Route")
IP Address Enter the IP address assigned to LAN port. The default setting is 192.168.2.1.
Subnet Mask Enter the subnet mask. The default setting is 255.255.255.0.
DHCP Server Enable Enable or disable DHCP server capability. The default setting is "Yes".
DNS Server 1 Enter DNS server address 1. The default setting is 8.8.8.8.
DNS Server 2 Enter DNS server address 2. The default setting is 208.67.222.222.
Allow IP Address
Enter the DHCP IP Pool starting address. The default setting is 192.168.2.100.
From
Allow IP Address To Enter the DHCP IP Pool ending address. The default setting is 192.168.2.254.
Default Gateway Configure the default gateway assigned by the DHCP server.
Default IP Lease
Enter the IP lease time (in seconds). The default setting is 43200.
Time
Layer 2 QoS Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
802.1Q/VLAN Tag 0.
Layer 2 QoS 802.1p Assign the priority value of the layer 2 QoS packets for LAN port. The default value
Dual
Both ports can be used for uplink connection. Users will need assign LAN 1 or
LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface.
UCM6100 Series User Manual
Version 1.0.18.13
P a g e | 58