1. Make sure the feature code for "Audio Mix Record" is configured and enabled.
2. After establishing the call, enter the "Audio Mix Record" feature code (by default it's *3) followed by # or
SEND to start recording.
3. To stop the recording, enter the "Audio Mix Record" feature code (by default it's *3) followed by # or SEND
again. Or the recording will be stopped once the call hangs up.
4. The recording file can be retrieved under Web GUI→CDR. Click on
click on
to download the recording file.
The above recorded call's recording files are also listed under the UCM6100 Web GUI→CDR→Recording Files.
Enable Spy
If "Enable Spy" option is enabled, feature codes for Listen Spy, Whisper Spy and Barge Spy are available for
users to dial from any extension to perform the corresponding actions.
Assume a call is on-going between extension A and extension B, user could dial the feature code from extension
C to listen on their call (*54 by default), whisper to one side (*55 by default), or barge into the call (*56 by default).
Then the user will be asked to enter the number to call, which should be either side of the active call, extension
A or B in this example.
----------------------------------------------------------------------------------------------------------------------------- ----------------------
Figure 202: Download Recording File from CDR Page
Figure 203: Download Recording File from Recording Files Page
UCM6100 Series User Manual
Version 1.0.18.13
to show and play the recording or
P a g e
|
309