Table 58: Iax Peer Trunk Configuration Parameters - Grandstream Networks UCM6100 Series User Manual

Enabled) → Trunk Username/CallerID (Keep Trunk CID Enabled) → DOD →
Extension CallerID Number → Trunk Username/CallerID (Keep Trunk CID
Disabled) → Global Outbound CID.
Configure the name of the caller to be displayed when the extension has no
CallerID Name
CallerID Name configured.
Username Enter the username to register to the trunk from the provider.
Password Enter the password to register to the trunk from the provider.
Advanced Settings
Select audio and video codec for the VoIP trunk. The available codecs are: PCMU,
Codec Preference PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, iLBC, ADPCM,
H.264, H.265, H.263, H.263p and VP8.
If enabled, the UCM6100 will regularly send SIP OPTIONS to the device to check
Enable Heartbeat
Detection
if the device is still online. The default setting is "No".
When "Enable Heartbeat Detection" option is set to "Yes", configure the interval
Heartbeat Frequency (in seconds) of the SIP OPTIONS message sent to the device to check if the device
is still online. The default setting is 60 seconds.
The maximum number of concurrent calls using the trunk. The default settings 0,
Maximum Number of
Call Lines
which means no limited.
Select Fax mode. The default setting is "None".
•
•
Fax Mode
Basic Settings
Configure a unique label to identify this trunk when listed in outbound rules,
Provider Name
inbound rules etc.
Host Name Configure the IP address or URL for the VoIP provider's server of the trunk.
If enabled, the trunk CID will not be overridden by extension's CID when the
Keep Trunk CID
extension has CID configured. The default setting is "No".
Disable This Trunk If selected, the trunk will be disabled.
Caller ID Configure the Caller ID. This is the number that the trunk will try to use when
None: Disable Fax.
Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this
extension. If no Email address can be found for the user, the Fax will be sent
to the default Email address configured in Fax setting page under Web
GUI→Call Features→Fax/T.38.

Table 58: IAX Peer Trunk Configuration Parameters

UCM6100 Series User Manual
Version 1.0.18.13
P a g e | 190