Ring Delay
Hold Access
Sample Configuration
1. On the UCM6100, go to Web GUI→Extension/Trunk→Analog Trunks page. Create analog trunk or edit
the existing analog trunk. Make sure "SLA Mode" is enabled for the analog trunk. Once enabled, this analog
trunk will be only available for the SLA stations created under Web GUI→Extension/Trunk→SLA Station
page.
2. Click on "Save". The analog trunk will be listed with trunk mode "SLA".
3. On the UCM6100, go to Web GUI→Extension/Trunk→SLA Station page, click on "Add". Please refer to
section
[Create/Edit SLA Station]
stations to monitor the analog trunk. The following figure shows two stations, 1002 and 1005, are configured
to be associated with SLA trunk "fxo1".
Configure the time (in seconds) for delay before ringing the station when a call
first coming in on the shared line. No delay is set by default. If set to 0, there will
be no delay.
This option defines the competence of the hold action for one particular trunk. If
set to "open", any station could hold a call on that trunk or resume one held
session; if set to "private", only the station that places the trunk call on hold could
resume the session. The default setting is "open".
Figure 103: Enable SLA Mode for Analog Trunk
Figure 104: Analog Trunk with SLA Mode Enabled
for the configuration parameters. Users can create one or more SLA
UCM6100 Series User Manual
Version 1.0.18.13
P a g e
|
196