Power On And Off - Sharp AR-M237 Copier Manual

POWER ON AND OFF

The power switch is located on the left side of the machine.
When the power switch is turned on, the machine starts up in the previously used mode. The following
Note
explanations assume that the previously used mode was copy mode.
POWER ON
Turn the power switch to the "ON" position.
ON
• When the power switch is turned to the "ON" position,
the message "WARMING UP. A COPYING JOB CAN
BE SET NOW." will appear in the message display and
the machine will start warming up. When "READY TO
COPY." appears, the machine is ready to copy. Copy
settings can be selected during warm-up.
• If auditing mode is enabled, "ENTER YOUR
ACCOUNT NUMBER." will appear. When a valid
account number is entered, the account status will
appear on the main screen for several seconds.
Then copying can be performed. (See "Key
operator's guide".)
If the fax option is installed, be sure to keep the power turned on. Faxes cannot be received when the power is
Note
turned off.
POWER OFF
When the machine is not used for a long time, be sure
to turn it off.
Make sure that the machine is not in operation
and then turn the power switch to the "OFF"
position.
OFF
If the power switch is turned off while the machine is in
operation, a misfeed may occur and the job that was in
progress will be canceled.
1
13