Job Program Memory; Storing A Job Program - Sharp AR-M237 Copier Manual

JOB PROGRAM MEMORY

If you frequently use the same settings for copy jobs, you can store in the settings in a job program. Up to 10 job
programs can be stored, and the programs are retained even when the power is turned off. By storing frequently
used copy settings in a program, you can eliminate the bother of selecting the settings each time you use them for a
copy job.
G After a job program is stored, if any settings of the key operator programs related to the stored job program are
prohibited, the related settings in the job program will not be recalled.
G If the overwriting of job programs is prohibited in the key operator programs, it will not be possible to overwrite or
delete a job program.
G To exit job program memory mode, press the [CLEAR ALL] key (
key on the touch panel.

STORING A JOB PROGRAM

1
Press the [ ] key.
S
ACC.#-C
2
Touch the [STORE/DELETE] key.
NUMBER.
ECALL STORE/DELETE
3
Touch a program number from 1 to 10
in the storage register screen.
ROGRAMS
SS PROGRAM NUMBER.
RECALL STORE
If a numeric key is selected that has already
Note
been programmed, a confirmation screen
will appear. To replace the existing program
with the new program, touch the [STORE]
key and continue from step 4. If you do not
wish to replace the existing program, touch
the [CANCEL] key to return to the above
screen and select a different numeric key.
54
) on the operation panel or touch the [EXIT]
4
Select the copy settings that you wish
to store in the program.
TO STORE, MAKE SELECTIONS AND PRESS
[OK], TO DELETE, PRESS [CANCEL].
SPECIAL MODES
2-SIDED COPY
8½x11
8½x14
OUTPUT
5
Touch the [OK] key.
D PRESS
CANCEL OK
EL].
AUTO
EXPOSURE
AUTO 8½x11
8½x11
PAPER SELECT
8½x11
8½x14
100%
COPY RATIO
The number of copies
cannot be stored.
The selected settings will
be stored under the
program number
selected in step 3.