Using The Document Glass - Sharp AR-M237 Copier Manual

AUTOMATIC TWO-SIDED COPYING
Two originals can be automatically copied onto both sides of a single sheet of paper. When the RSPF is used,
two-sided copies of two-sided originals can easily be made.
Document glass
RSPF
• Paper sizes that can be used are 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 14" and 11" x 17" (A5, B5,
Note
B5R, A4, A4R, B4, and A3).
• When making two-sided copies on letterhead paper, place the side with the letterhead face down if using a
tray, or face up if using the bypass tray (This is the opposite of normal.).
• Automatic two-sided copying is not possible on thick paper, thin paper, labels, transparency film, envelopes, and
other special types of paper.
• If automatic two-sided copying is performed using super photo mode, the memory may become full
("MEMORY IS FULL, SELECT ANOTHER EXPOSURE MODE." will appear.). Touch the [OK] key to cancel
automatic two-sided copying, set the exposure setting to other than super photo mode, and select automatic
two-sided copying once again.
• Automatic two-sided copying can be disabled in the key operator programs. (See the "Key operator's guide".)
• When dual page copy (p.43) is selected, two-sided original to two sides or two-sided original to one side cannot be used.

USING THE DOCUMENT GLASS

1
Place the original on the document
glass. (p.22)
2
Touch the [2-SIDED COPY] key.
2-SIDED COPY
OUTPUT
3
Touch the [One-sided to two-sided
copy] key.
One-sided original
One-sided original
¡
Two sides
( )
Original ¡ ¡ ¡ ¡ Paper
¡
Two sides (
Two-sided original
¡
Two sides
( )
Touch the [BINDING CHANGE] key when making the tablet
binding, or when making automatic two-sided copies of a
one-sided 11" x 17" or 8-1/2" x 14" size portrait original,
touch the [BINDING CHANGE] key.
Portrait-oriented original
(11" x 17" or 8-1/2" x 14" size)
Before [BINDING CHANGE]
4
Touch the [OK] key.
OK
BINDING
CHANGE
)
Two-sided original
¡
One side
( )
After [BINDING CHANGE]
27
2