Originals That Can Be Faxed; Original Sizes - Sharp AR-M237 Copier Manual

ORIGINALS

ORIGINALS THAT CAN BE FAXED

Original sizes

Using the RSPF
Using the document glass
• Originals that are not a standard size (5-1/2" x 8-1/2", 5-1/2" x 8-1/2"R, 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 14",
Note
11" x 17") can also be faxed.
• There are restrictions on originals that can be scanned using the RSPF. See
MAKING COPIES
*Long originals
Depending on the resolution setting and the width of the original, there may not be sufficient space in memory to hold a
long original. In this case, refer to the following table and select a lower resolution setting and/or shorten the original.
11" wide
Standard 39.3" (1000 mm)
Fine 39.3" (1000 mm)
Super fine 39.3" (1000 mm)
Ultra fine 34.6" (880 mm)
Scanning area of original
Note that the edges of an original cannot be scanned.
Area that cannot be scanned : 0.2" (5 mm) or less at top edge
Automatic reduction of faxed document
If the width of the faxed document is greater than the receiving machine's maximum receivable width, the document
will be automatically reduced.
Faxed document width
11" x 17"
11" x 17"
8-1/2" x 14"
A document can also be faxed without reducing its size. In this case, the left and right edges will not be transmitted.
("AUTO RECEIVE REDUCE SETTING" (p.101))
Minimum original size
8-1/2" (width) x 5-1/2" (length)
(210 mm (width) x 148 mm (length))
5-1/2" (width) x 8-1/2" (length)
(148 mm (width) x 210 mm (length))
" in
the operation manual for copier.
8-1/2" wide
39.3" (1000 mm)
39.3" (1000 mm)
39.3" (1000 mm)
39.3" (1000 mm)
and 0.2" (5 mm) or less at bottom edge
: Near edge + far edge = 0.24" (6 mm) or
less
Receiving machine's
paper width
8-1/2" x 14"
8-1/2" x 11"
8-1/2" x 11"
11" (width) x 39.3"* (length)
(297 mm (width) x 1000 mm (length))
* Long originals can be loaded.
11" (width) x 17" (length)
(297 mm (width) x 420 mm (length))
(unit : inch)
Top edge
Area that cannot
be scanned
Reduced size
8-1/2" x 14"
8-1/2" x 11"R
8-1/2" x 11"R
Maximum original size
"
POINTS TO NOTE WHEN
Far edge
Bottom edge
Near edge
Ratio
1 : 0.70 (Area ratio)
1 : 0.5 (Area ratio)
1 : 0.64 (Area ratio)
1
9