Power On And Off; Power On; Power Off - Sharp AR-7024 Operation Manual

POWER ON AND OFF

The power switch is located on the left side of the machine.

POWER ON

Turn the power switch to the "ON"
position.
• The machine reverts to the initial settings when it is first turned on, when the [CLEAR ALL] key (
Note
or when no keys are pressed for the preset "Auto clear" time following the end of a copy job. When the machine
reverts to the initial settings, all settings and functions selected to that point are cancelled. The "Auto clear" time
can be changed in the user settings.
• The machine is initially set to automatically enter power save mode if not used for copying or printing, for a
preset period of time. This setting can be changed in the system settings.
Power save modes
The machine has two power save modes to reduce overall power consumption thereby reducing the cost of
operation. In addition, these modes conserve natural resources and help reduce environmental pollution. The two
power save modes are "Preheat mode" and "Auto power shut-off mode".
Preheat mode
This function automatically switches the machine to a low power consumption state if the set duration of time
elapses without the machine being used when the power is on. The POWER SAVE indicator (
however, the keys on the operation panel can be used. Normal operation automatically resumes when a key on the
operation panel is pressed, an original is placed, or a print job is received.
Auto power shut-off mode
This function automatically switches the machine to a state that consumes even less power than preheat mode if the
set duration of time elapses without the machine being used when the power is on. The POWER SAVE indicator
( ) will blink. To resume normal operation, press the [POWER SAVE] key (
automatically when a print job is received. While in auto power shut-off mode, no keys (except the [POWER SAVE]
key ( )) can be used.
The preheat activation time and the "Auto power shut-off timer" can be changed using system settings. It is
Note
suggested that you set times that are appropriate for your usage of the machine.
Initial settings
The machine assumes the initial settings when it is first turned on, when the [CLEAR ALL] key (
and approximately one minute after the last copy is made in any mode.
Copy ratio: 100%, Exposure: Automatic
Copy quantity: 0, All special copier modes: Off
Auto paper selection: On, Paper feed station: The tray selected in the "Default tray setting" in the system settings.
While the machine is
warming up, the [START]
key( ) will blink.
(The [START] key( )
will light when the
machine is ready to
copy.)
(p.93)

POWER OFF

Make sure that the machine is not in
operation and then turn the power switch
to the "OFF" position.
Check the following to make sure the machine is not in
operation:
• The START indicator is lit. (Initial state)
• The POWER SAVE indicator (
( )will lit. (Preheat mode)
• The POWER SAVE indicator (
power shut-off mode)
(p.93)
). Normal operation also resumes
(p.93)
If the power switch is
turned off while the
machine is in operation,
a misfeed may occur and
the job that was in
progress will be
cancelled.
) and [START] key
) will blink. (Auto
) is pressed,
) lights up,
) is pressed,
(p.95)
37
2