Initial Resolution Setting; Own Number And Name Set; Pause Time Setting - Sharp AR-M237 Copier Manual

INITIAL RESOLUTION SETTING

This setting is used to select the default resolution
setting for fax mode. Selections are [STANDARD],
[FINE], [SUPER FINE], and [ULTRA FINE]. When the
resolution is set to [FINE], [SUPER FINE], or [ULTRA
FINE], [HALF TONE] can also be selected. To select
HALF TONE for the selected resolution setting, touch
the [HALF TONE] key so that it is highlighted.
The factory default setting is "STANDARD".
• HALF TONE cannot be selected for
Note
STANDARD resolution.
• For information on each of the resolution
settings, see page 21.
INITIAL EXPOSURE SETTING
This program is used to set the default exposure for
scanning in fax mode.
[AUTO] or [MANUAL] can be selected for the
exposure. When [MANUAL] is selected, the exposure
can be adjusted to one of five levels. [1] is the lightest
level and [5] is the darkest level.
The factory default setting is "AUTO".

OWN NUMBER AND NAME SET

Use this program to enter, edit, or delete the fax
number of the machine and the sender's name. The
entered name and number are printed at the top of
each fax page that is sent. The number is also used as
a passcode when performing polling reception.
You can check your entries by printing out the Sender
List in the custom settings. (p.85)
If multiple senders have been programmed
Note
and a sender is not selected, the sender
with the lowest control number is
automatically selected.
Entering the sender's name and number
1
Touch the [ENTER] key.
The new entry screen appears.
KEY OPERATOR PROGRAMS
OWN NUMBER AND NAME SET
ENTER
2
Touch the [NAME] key and enter the
sender's name.
The sender's name entry screen appears.
Up to 20 sender's names can be entered.
A maximum of 22 characters can be entered for a
sender's name.
To enter characters, see "ENTERING CHARACTERS"
on page 80.
You can also program only a name or only a
Note
number as a sender.
OK
AMEND/DELETE
KEY OPERATOR PROGRAMS
3
Touch the [FAX No.] key and enter the fax
number.
Enter up to 20 digits for the number using the numeric
keys.
To enter a "+", press the "
To enter a hyphen, touch the [PAUSE] key. To enter a
space, press the [SPACE] key.
If you make a mistake, press the [CLEAR] key (
re-enter the correct digit.
4
Touch the [OK] key.
5
To exit, touch the [EXIT] key.
• To enter another sender, touch the [NEXT] key.
Editing or deleting a sender
1
Touch the [AMEND/DELETE] key.
2
Touch the sender key that you wish to edit
or delete.
3
Touch the keys that wish to edit or delete.
• To edit sender information, follow the same steps as
when storing the sender.
• To delete a sender, touch the [DELETE] key in the
upper right corner of the screen and then touch the
[YES] key in the message screen that appears. (To
cancel the deletion, touch the [NO] key.)
DIAL MODE SETTING
(Setting your line type)
Select the type of telephone line you are on.
Touch [TONE] or [PULSE].
The factory default setting is "TONE".

PAUSE TIME SETTING

This setting is used to select the duration of the pause
that is inserted in a destination fax number when the
[PAUSE] key is pressed while dialing or storing the
number.
Any number of seconds from 1 to 15 can be selected.
The factory default setting is "2" (sec.).
" key.
) and
97
8