Sharp AR-M237 Copier Manual page 137

8
Place the next set of original pages
and press the [START] key (
Repeat this step until all pages have been scanned.
You can change the original size, resolution, and
exposure settings as needed for each page.
If you take no action for about 1 minute (you do not
press the [START] key (
ends and the job is stored for transmission.
• If the memory becomes full while originals are being scanned, a message will appear and scanning will stop.
Note
The page that was being scanned when the memory became full will be cleared. To transmit only the originals
that have already been scanned, touch the [SEND] key. To cancel the transmission, touch the [CANCEL] key.
• Depending on the content of the originals, the memory may become full before 100 pages are scanned.
• When using job build mode, the number of originals scanned will appear in the display. When the count
reaches 256 pages, it will reset to 0 and further scanned pages will be counted from 1.
• When using job build mode, the original size can be changed between originals.
• When scanning the first set of originals, the [ROTATE THE IMAGE 90 DEGREES] checkbox can be selected,
however, from the second set of originals on, the selection cannot be changed until scanning is finished (the
checkbox will be grayed out).
• Direct transmission is not possible when using job build mode. A job build transmission takes place as a
memory transmission even if Quick Online is enabled (transmission does not begin until all originals are
scanned).
).
)), scanning automatically
9
When the last original page has been
scanned, touch the [READ-END] key.
(Pg.No. 2)
L.
ESS [READ-END]
READ-END
If you do not touch the [READ-END] key to
Note
complete the procedure, the screen will
automatically revert to the initial screen after
60 seconds. If desired, you can disable
automatic return to the initial screen by
changing a setting in the key operator
programs. (See "DISABLE DISPLAY
TIMEOUT" in the key operator's guide.)
When the screen reverts to the initial
screen, the scanned originals will be
transmitted.
BASIC OPERATIONS
A beep sounds to inform
you that the job has been
stored for transmission.
[JOB STORED.] appears
in the message display.
(Dialing and transmission
begin automatically when
any previously stored
jobs are completed.)
19
2