Condition Setting Screen - Sharp AR-M237 Copier Manual

FAX MODE (CONDITION SETTING SCREEN)
The condition setting screen of fax mode is displayed by pressing the [FAX] key while the print mode, copy mode, or
job status screen appears in the touch panel. In the explanations that follow, it is assumed that the initial screen that
appears after pressing the [FAX] key is the condition setting screen (shown below). If you have set the display to
show the address directory (p.8) when the [FAX] key is pressed, touch the [CONDITION SETTINGS] key in the
address directory to display the condition setting screen.
A key operator program can be used to set the display to show either the condition setting screen (shown below) or
the address directory screen (p.8) when the [FAX] key is pressed ("DEFAULT DISPLAY SETTINGS" (p.96)).

Condition setting screen

The display is initially set (factory setting) to show the following screen when the [FAX] key is pressed.
14
13
12
11
Message display
1
Messages appear here to indicate the current
status of the machine. When the machine is ready
to send, an icon appears to the left.
Memory and reception mode display
2
This shows the amount of fax memory that is free
and the currently selected reception mode.
[SPEAKER] key (p.11)
3
This key is used for dialing with the speaker.
During dialing it changes into the [PAUSE] key,
and after pressing the [SUB ADDRESS] key it
changes into the [SPACE] key.
[REDIAL] key (p.11)
4
Touch this key to redial the most recently dialed
number. After dialing, this key changes into the
[NEXT ADDRESS] key.
[ADDRESS BOOK] key (p.16)
5
This displays the Address Directory screen (p.8).
Touch this key when you want to use an auto-dial
number (rapid dialing or group dialing).
[SUB ADDRESS] key (p.53)
6
Touch this key to enter a sub-address or
passcode.
[ADDRESS REVIEW] key (p.27)
7
When performing a broadcast transmission, touch
this key to check your selected destinations. A list
of your selected destinations will appear, and
destinations can be deleted from the list.
1
READY TO SEND.
AUTO
EXPOSURE
STANDARD
RESOLUTION
AUTO
ORIGINAL
10 9
BEFORE USING THE FAX FEATURE
2 3
SPEAKER REDIAL
FAX MEMORY:100%
ADDRESS
AUTO RECEPTION
BOOK
SUB ADDRESS
SPECIAL MODES ADDRESS REVIEW
DIRECT TX MEMORY TX
[DIRECT TX
8
Touch this key to switch from memory
transmission mode to direct transmission mode.
The selected mode is highlighted.
[SPECIAL MODES] key
9
Touch this key to select one of the following
special functions:
• Timer transmission (p.30) • Polling (p.33)
• Slow scan mode (p.39) • Dual page scan (p.40)
• Program (p.41) • Memory box (p.48)
• Cover sheet (p.42) • TX message (p.43)
• Sending options (p.47 and p.50)
• Own passcode select (p.45)
Original settings icon display
10
When two-sided scanning (p.17) or job build mode
(p.18) is selected (touch the [ORIGINAL] key to
select these functions), an icon will appear in this
display.
The icon can be touched to open the original
settings screen.
[ORIGINAL] key (p.20)
11
Touch this key to manually set the original size or
select two-sided scanning.
[RESOLUTION] key (p.21)
12
Touch this key to change the resolution setting
when scanning an original. The selected resolution
setting will be highlighted above the key. The initial
factory setting is [STANDARD].
4
5
6
7
8
MEMORY TX] key (p.14)
1
7